Tip for the newbies,

[eagle61_PREV (deleted)]

When you merge on an interstate from the right use the outside lane,that will eliminate people cutting you off because they were in the wrong lane or they were not paying attention .When you pass a truck in a curve be sure and pass on the lower side against the curve,if you pass on the high side of the curve and his load shifts guess where he will end up dont be ignorant. The job we do is getting harder every day Pay attention!

[smartsolutuions]

To respond to eagle61 post u should only turn into outside lane if ur turning lanehas two lanes u should allways use the outside lane if makeing a right turn to get on ramp u should turn from outside lane if there is one if no outside lane u should turn into your lane your comeing from to keep other vehicles from compromiseing theres and urs safety AND in reguard to ur post about passing another semi u should never pass anyone in the inside lane this is illegal and not safe u also should never pass in a curve over railroad tracks over a bridge ect. doing so is not safe and in some cases illegal u should also never impair the safety of any driver around u when makeing a pass in the outside lane u should never take more then 7 seconds if u r takeing to long u a putting not only u but the other driver in a unsafe place












[/i]